Optoma pd50 Benutzerhandbuch
5
Safety Precautions
Set up
Do not place the High Definition Plasma Display on sloped or unstable surfaces.
The High Definition Plasma Display may fall off or tip over.
Do not place any objects on top of the High Definition Plasma Display.
If water spills onto the High Definition Plasma Display or foreign objects get inside it, a short-circuit may occur
which could result in fire or electric shock. If any foreign objects get inside the High Definition Plasma Display,
please consult an Authorized Service Center.
which could result in fire or electric shock. If any foreign objects get inside the High Definition Plasma Display,
please consult an Authorized Service Center.
Do not cover the ventilation holes.
Doing so may cause the High Definition Plasma Display to overheat, which can cause fire or damage to the
High Definition Plasma Display.
If using the pedestal (optional accessory), leave a space of 10 cm (approx. 4 inches) or more at the
top, left and right, 6 cm (approx 2.5 inches) or more at the bottom, and 7 cm (approx. 3 inches) or
more at the rear. If using some other setting-up method, leavea space of 10 cm (approx. 4 inches) or
more at the top, bottom, left and right, and 1.9 cm (approx. 1 inches) or more at the rear.
top, left and right, 6 cm (approx 2.5 inches) or more at the bottom, and 7 cm (approx. 3 inches) or
more at the rear. If using some other setting-up method, leavea space of 10 cm (approx. 4 inches) or
more at the top, bottom, left and right, and 1.9 cm (approx. 1 inches) or more at the rear.
As illustrated below, if an outside antenna is connected to the television equipment, be sure the
antenna system is grounded so as provide protection against voltage surges. US section 810 of the
National Electrical Code provides information with respect to proper grounding of the mast and
supporting structure. Grounding of the lead-in wire to an antenna discharge unit, size of grounding
conductors, location of antenna discharge unit, connection to grounding electrodes, and
requirements for the grounding electode.
antenna system is grounded so as provide protection against voltage surges. US section 810 of the
National Electrical Code provides information with respect to proper grounding of the mast and
supporting structure. Grounding of the lead-in wire to an antenna discharge unit, size of grounding
conductors, location of antenna discharge unit, connection to grounding electrodes, and
requirements for the grounding electode.
AC Power Supply Cord
Securely insert the power cord plug as far as it will go.
If the plug is not fully inserted, heat may be generated which could fire. If the plug is damaged or the wall
socket plate is loose, they should not be used.
Do not handle the power code plug with wet hands.
Doing so may cause electric shocks.
Do not do anything that might damage the power cable. When disconnecting the power cable, hold
the plug, not the cable.
the plug, not the cable.
Do not make any modifications, place heavy objects on, place near hot objects, heat, bend, twist or
forcefully pull the power cable. Doing so may cause damages to the power cable which can cause fire or
electric shock. If damage to the cable is suspected, have it repaired at an Authorized Service Center.
electric shock. If damage to the cable is suspected, have it repaired at an Authorized Service Center.
If the Plasma Display is not in use for a long period of time, unplug the power cord from the wall
outlet.
outlet.
N O T E
Do not allow a still picture to be displayed for an extended period, as this may cause a permanent after-image
to remain on the High Definition Plasma Display, which will not be covered by the product.
Antenna lead-in
Antenna discharge
Grounding
Grounding clamps
Power service
Electronic service