Lowrance 540c baja Bedienungsanleitung

84 

Steer with Arrows 
When you are using the Steer with Arrows command, you can press 

 to clear the steering and speed boxes from the screen while con-

tinuing the simulation. This action will allow you to use the map cursor 

during a simulation. To turn steering and speed boxes back on again, 

return to the GPS Simulator menu, highlight the 

 

command, press 

.

Press 

repeatedly to return to the previous 

page. 

Simulating Trail or Route Navigation 
In Simulator mode, your unit can automatically follow a trail or route 

without manual steering if you use these steps: 
1. From the Map Page, go to the simulator menu. Pick a 

 at or near the beginning of your trail/route. Enter an approximate 

 (shown in compass degrees) that will point you toward the start 

of the trail/route. 
2. Set 

 to zero. Select 

 command and press 

, 

which turns on the simulator and returns you to the Map Page. 
3. Begin navigating along the trail/route. (If you are close enough to the 

first waypoint, the arrival alarm will usually go off as soon as naviga-

tion begins. Press 

 to clear the alarm.) When navigation starts, 

press 

↑ to increase speed to the desired setting. 

4. Press 

 to turn off the steering and speed boxes. The unit will now 

automatically steer along the trail or route. Cancel navigation when 

you arrive at your destination. 

This command is handy when you are practicing in simulator mode. (See 
the entry in this section for GPS Simulator.) In simulator mode, this 

command makes the unit operate as if it is sitting someplace other than 

its actual location. So, you and your unit could be located in Kansas City, 

but easily practice navigating in the ocean off Islamorada, Florida. 
1. Press 

|

|

↓ to 

|

|

. 

2. A message appears, telling you to move the cursor near the desired 

location and press 

. When the message automatically clears, follow 

the message instructions. 
3. In a moment, your present position marker arrow appears on the 

map in the location you selected with the cursor. The unit will consider 

that spot as its last known position until changed by either a live satel-

lite lock-on or a new simulator location.