Lowrance hunt c Bedienungsanleitung

81

To select a coordinate system:

To change the coordinate system, press 

|

 while 

 is highlighted. Use the 

↑ or ↓ arrow keys to highlight the desired

format. Press 

 to select it. Press 

repeatedly to get back to the

main display.

To set up Loran TD:

NOTE:

If the Loran TD conversion is chosen, you must enter the local Lo-
ran chain identification for the master and slaves. Do this by se-
lecting 

 and pressing 

|

, then choosing the ID.

Press 

 to close this menu.

Configure Loran TD menu.

Map Fix
Map Fix is used with charts or maps. This system asks for a reference
position in latitude/longitude, which you take from a marked location
on the map. It then shows the present position as distance on the map
from that reference point.

For example, if it shows a distance of UP 4.00" and LEFT 0.50", you
then measure up four inches and to the left a half-inch from the refer-
ence point on the map to find your location.
To configure a map fix:
To use this format, you need to follow these steps in order. First, take
your map of the area and determine a reference latitude/longitude.
(Note: in order for this system to work, the latitude/longitude lines must
be parallel with the edge of the map. USGS maps are parallel, others
may not be. Also, this works better with smaller scale maps.) The refer-
ence position can be anywhere on the map, but the closer it is to your
location, the smaller the numbers you'll have to deal with.