Extreme 10808 Installationsanleitung

Extreme Networks Consolidated XOS Hardware Installation Guide

The 10/100BASE-TX Ethernet management port allows you to communicate directly to the Central 
Processing Unit (CPU) of the switch. You can plug an Ethernet cable directly from your laptop into the 
management port, which provides you direct access into the switch. This access allows you to view and 
locally manage the switch configurations. 

Do not assign an in-band IP address to the management port VLAN. The management port VLAN is an 
out-of-band VLAN, so if it is assigned an in-band IP address (an address where the source and 
destination are in the same subnet), the switch treats it as a normal VLAN and attempts to route traffic 
through it.

Extreme Networks does not recommend that you use the management port to route traffic to any front 
panel port on the switch. The management port is designed for switch management purposes.

The BlackDiamond 10K series and BlackDiamond 8810 switches support the small form pluggable (SFP) 
Gigabit interface converter (GBIC), also known as the mini-GBIC. The switches and the modules 
identify the type of mini-GBIC that is installed.

The three types of mini-GBIC interfaces are: 

●

SX mini-GBIC, which conforms to the 1000BASE-SX standard

●

LX mini-GBIC, which conforms to the 1000BASE-LX standard

●

ZX mini-GBIC, which conforms to the IEEE 802.3z standard

Use only Extreme Networks-certified mini-GBICs, available from Extreme Networks, in the mini-GBIC 
port in the switch or module.

 describes the specifications for the SX mini-GBIC interface, 

 describes the specifications 

for the LX mini-GBIC interface, and 

 describes the specifications for the ZX mini-GBIC interface.

Transceiver 

Optical output power

-9.5 dBm

-4 dBm

Center wavelength

830 nm

850 nm

860 nm

Optical input power sensitivity

-21 dBm

Optical input power maximum

-4 dBm

Operating wavelength

830 nm

860 nm

General 

Total system budget

11.5 dB