Extreme 10808 Installationsanleitung

Extreme Networks Consolidated XOS Hardware Installation Guide

Grasp the memory card between your thumb and forefinger.

For the BlackDiamond 10K series switch, the side with the ridge faces to the left of the chassis.

For the BlackDiamond 8810 switch, the side with the ridge faces toward the bottom of the chassis.

Slide the card into the compact flash slot until you feel resistance. A portion will extrude from the 
slot.

Gently push the card until it is seated into the slot. The card should be fully inserted, or seated, 
inside the slot.

To verify that the card is fully seated, use the 

show memorycard

 command. 

You do not need to power off the system or remove the MSM from the chassis to remove an external 
memory card. 

Use the 

eject memorycard

 command to ensure that you do not lose any data when you remove the 

card. After you issue the 

eject memorycard

 

command, you can manually remove the card from the 

external compact flash slot on the MSM. For more information about the 

eject memorycard

 command, 

see the ExtremeWare XOS Concepts Guide.

To manually remove the external compact flash memory card, do the following:

Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of 
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the 
switch front panel.

Locate the black release pin that sits just above the compact flash slot.

Press the release pin in until the card releases from the slot. 

The card releases to an intermediate position; the card remains partially inserted but is no longer 
seated in the slot.

Using your thumb and forefinger, remove the card completely and place it in a safe location.