Ergodex dx1 Betriebsanweisung
14
few moments. If the installer program does not load automatically,
run "Install.exe" from the Installation CD.
When the installer program loads, click on "Install Software" and
follow the on-screen instructions to install Ergodex Manager.
During the installation, you will be prompted to plug in your DX1 Pad.
When asked, plug the USB cable into one of your computer’s
powered USB ports. The port should be marked with the USB
symbol shown below.
run "Install.exe" from the Installation CD.
When the installer program loads, click on "Install Software" and
follow the on-screen instructions to install Ergodex Manager.
During the installation, you will be prompted to plug in your DX1 Pad.
When asked, plug the USB cable into one of your computer’s
powered USB ports. The port should be marked with the USB
symbol shown below.
For Window® XP
After plugging in the Pad, the Windows® "Found New Hardware
Wizard" will open. (If Windows® Update is enabled, you will start at
Screen 1, otherwise you will start at Screen 2.)
Wizard" will open. (If Windows® Update is enabled, you will start at
Screen 1, otherwise you will start at Screen 2.)
Note: Windows® XP manages each USB port separately. Windows®
XP will require that you go through this installation process each time
you plug the DX1 Pad into a new USB port on your computer.
Getting Started
Screen 1
Screen 2
Screen 3
Screen 4
Select “No, not this time”
and click “Next”
and click “Next”
Select “Install the software
automatically” and click “Next”
automatically” and click “Next”
Wait for installer to complete
Click “Finish” to close the
wizard.
wizard.