Intermec 2430 Betriebsanweisung

 

Check the Network-EAP check box for Accept Authentication 
Type. 

Click OK. 

On your Trakker Antares terminal, set the User Name and Password 
parameters. 

Scan this bar code to access the TRAKKER Antares 2400 Menu 
System: 

 

 

TRAKKER Antares 2400 Menu System 

   

*..-.* 

  *..-.* 

  The Main Menu appears. 

Choose Configuration Menu > Communications Menu > Radio. 

Use the arrow keys to scroll to the LEAP screen and set the User 
Name and Password parameters. 

If you just want to make sure that your terminal can be authenticated, 
you can use the default values of “anonymous” and “anonymous.” 
However, Intermec recommends that you set your permanent user 
name and password to unique values. For help, see Chapter 6, 
“Configuration Command Reference,” in the 2400 Family system 
manual. 

Exit the menu system and save all changes. 

When the terminal is authenticated, it emits a low beep and then a high 
beep. The application that was running on the terminal, if any, resumes. 

If authentication fails, the terminal emits a high beep and then a low 
beep. The terminal waits 60 seconds and restarts the authentication 
process.  

241X, 242X, 243X, 2455, 2475, and 248X. 

The Time Zone configuration command sets the time zone on Trakker 
Antares terminals. With firmware version 8.02, you can now set the time 
zone using positive or negative values from -14 to +14 in increments of 15 
minutes from 0, which represents Universal Time (UT). 

DZdata 

Acceptable values for data are: 

+/- 

+ or - 

 

Positive or negative 

hh 

0 to 14   

Hours 

:mm  15, 30, or 45  Minutes (optional) 

Not supported