ProctorSilex 41334 Betriebsanweisung

To Set Clock:
1. Plug in coffeemaker. 

Numbers on the 
clock will flash until 
you set time of day. 

2. To set time of day, press h. (hour) button to establish 

current hour. A red dot will glow to indicate PM hours. If
this dot is not glowing, clock is set for an AM hour.

3. Press m. (minute) button until you reach the current time.

To Set and Use Automatic Brew:
1. Make sure clock is set for correct time of day.
2. Fill coffeemaker with desired amount of water and coffee.

Place carafe with lid on keep-hot plate.

3. While holding Prog. (program) button, press h. and m.

buttons until desired brewing time is reached. 

4. Once brewing time has been set, follow this procedure

each day to reset the Automatic Brew:
A. Switch must 

be in Off 
position.

5. The Automatic Brew indicator dot on clock will glow.
6. Brew cycle will begin at set time.

B. Then slide

to Auto.

1. Before first use, clean coffeemaker by following steps 

listed in “To Clean the Inside of the Coffeemaker.” Use either
clean water or vinegar. If clock model, read the following section.

2. Place a large, cupcake-style disposable paper filter or 

permanent filter in brew basket.

3. For each cup of coffee being made, place one level tablespoon of

coffee into filter. Close brew basket, making sure it is fully closed.

4. Fill carafe with the desired amount of cold tap water.
5. Pour water from carafe into reservoir.
6. Place carafe, with carafe lid attached, on Keep-Hot Plate.
7. For models with Brew Selector, rotate knob to desired strength.

For clock models, see below for Automatic Brew option.

8. Turn switch ON. Turn OFF and unplug when finished.

1. Reservoir
2. Brew Basket
3. Carafe
4. Keep-Hot Plate

wWARNING

If coffeemaker overflows, allow the unit, coffee and grounds to
cool before cleaning the unit, coffee or grounds.

840151900 ENv03.qxd  8/17/06  1:54 PM  Page 4