McCall 1-1024uf Техническое Руководство

Cabinet - Cabinets are all metal, inside and out. The
top, back, and bottom are made of galvanized steel. In
addition, all seams are closed and sealed, with metal
edges turned away from the exposed surface. The
result is an integrated structural frame. Internal
corners are coved to conform to NSF standards.
Automatic interior lighting is controlled by a light
switch concealed in the door hinge, except glass door
models employ a manual switch.

Doors - Constructed of metal, refrigerator doors are
self-closing and fully insulated. Their cam-lift hinges
are chrome-plated and self-lubricating. Hinges also
have a safety stop that holds the door open,
preventing overswing. Chrome-plated pull handles
have built-in cylinder locks. The full-perimeter,
magnetic vinyl gaskets are removable without the use
of tools. Doors easily lift off, and door perimeters have
a built-in, low wattage, and anti-condensate heater.
Door openings are protected by an impact-resistant,
nonconductive PVC breaker strip with no exposed
screws or fasteners.

Insulation - Cabinet body, doors, and evaporator coil
housings are filled with pressure-injected
polyurethane foam.

Interior Shelves - Three wire shelves per section are
standard. Shelves have a runner spaced 3/4 inch O.C.
with two reinforcing bars 8 1/2 inch O.C. Coated with
7 mils of baked-on gray epoxy. The shelves have a
saline spray corrosion resistance of 600 hours.
Shelves will support 250 pounds each with maximum
cabinet load of 800 lbs. They are supported on
stainless steel pilasters, and are adjustable on 1 inch
centers. All three shelves are interchangeable and can
be adjusted without tools or special parts.

Self-Contained Refrigeration - The complete
refrigeration assembly is mounted on top of the
cabinet behind a removable hatch cover. 

Refrigeration components include a hermetically
sealed compressor, thermostatic expansion valve,
thermostatic temperature control, high-humidity

evaporator coil PSC evaporator motor relief vent, and
hot gas condensate evaporator. The system is
balanced to maintain -10°F average internal air
temperature. Windrunner gradient air displacement
process provides even air flow and temperature
control throughout the cabinet. Relief vent facilitates
access to cabinet.

All components are factory installed and tested, and
supplied with an attached cord and plug, (self-
contained, 115 volts less than 16 amps) master power
switch, and exterior digital thermometer (1000 series)
dial thermometer (2000-4000 series).

Remote Cabinets - Standard remote units are
provided with capped refrigeration lines, expansion
valve, solenoid valve, electric condensate evaporator,
and temperature control. Condensing unit is not
included. All other features are the same as self-
contained units, except power cord.

McCall Refrigeration specification sheets are available 
online @ www.mccallrefrigeration.com

Stainless steel cabinet interior and exterior front, sides and doors.

• Top mounted compressor and evaporator coil 
• Expansion valve 
• PSC Evaporator motor relief vent 
• Hot gas condensate evaporator 
• R-404A refrigerant
• Cord and plug attached (self-contained only) 
• Windrunner gradient air displacement process
• Exterior digital thermometer (1000 series) dial thermometer (2000-4000 series) 
• Self-closing cam-lift hinges 
• Chrome-plated door handles with security locks 
• 6 inch adjustable legs 
• Baked epoxy-coated shelves adjustable on 1 inch centers 
• Concealed light switch
• Stainless steel pilasters (1000 series) & aluminum pilasters (2000-4000 series)
• Adjustable doorstops

CLASSIFIED TO

NSF (STD-7-1999)