Benwin fx usb-d 2.0 Benutzerhandbuch
Left
Right
PC/ Laptop
Volume Control
USB Port
Left Speaker Signal Cable
USB Cable
Installation Instructions
1. Place both speakers in the desired location.
2. Turn the volume down on your speakers so that they are turned OFF.
3. Find the USB port on your computer or audio device.
4. Insert the USB plug (from the back of the right speaker) into the USB port
2. Turn the volume down on your speakers so that they are turned OFF.
3. Find the USB port on your computer or audio device.
4. Insert the USB plug (from the back of the right speaker) into the USB port
on your computer or audio device.
5. Power up your computer or audio device and adjust the volume levels on
both your computer or audio device and speaker system.
If your speakers do not work properly after installation, please refer to the section
titled Troubleshooting.
System Specifications
Total Power Output (RMS):
3W + 3W
Total Power Output (P.M.P.O.):
48W
Frequency Response:
60Hz – 20KHz
Driver:
2.75” Full Range &
1” Neomanic™ Microfoil
1” Neomanic™ Microfoil
Impedance:
4
Ohms
Page 2