Open House h634 Installationsanweisungen
The H634 Cable/DSL Router with 4-port Switch
connects multiple
computers to a DSL or cable modem. “Plug and play” installation is easy when using
the H628 data hub. The H634 is
IEEE 802.3u 100 Base-TX Fast
Ethernet compliant, IEEE 802.3
10
IEEE 802.3u 100 Base-TX Fast
Ethernet compliant, IEEE 802.3
10
Base-T compliant and has
activity LEDs for network status
and diagnosis. The H634 can
connect with up to four client
computers directly. Up to 253
computers can be connected
by using additional Ethernet
switches (H638) or hubs.
and diagnosis. The H634 can
connect with up to four client
computers directly. Up to 253
computers can be connected
by using additional Ethernet
switches (H638) or hubs.
Typical Telephone DSL Installation
Wiring the H634 Router
• Use only Category 5e unshielded twisted-pair cable for maximum
• Use only Category 5e unshielded twisted-pair cable for maximum
performance.
• When connecting to an H628 or a network device directly,
use straight through or crossover RJ-45 cables. All ports will
automatically detect the cable type.
automatically detect the cable type.
• Each run to a network device should be less than 100 meters
(328 feet).
LED Indicators
• PWR lights when power from transformer is present.
• RDY lights when router is ready for packet data from the WAN.
• WAN lights when wide area network packets are sent or received.
• 1-2-3-4 lights when packet data is being sent to, or received from,
• PWR lights when power from transformer is present.
• RDY lights when router is ready for packet data from the WAN.
• WAN lights when wide area network packets are sent or received.
• 1-2-3-4 lights when packet data is being sent to, or received from,
the client computers or additional hubs or switches.
Specifi cations: Typical @ 25°C ± 5°C
Compliance
IEEE 802.3u
IEEE 802.3
IEEE 802.3
100 Base-TX, 10 Base-T and N-way
auto-negotiation
Network Interface
RJ-45 ports
4 to client computers or hub/switch
RJ-45 WAN
1 from DSL/cable modem
Max Cable Length CAT-5e (UTP)
100 meters (328 feet)
LED Indicators
router & ports
PWR, RDY, WAN, Ports 1, 2, 3, & 4
Environmental
operating
temperature
temperature
0°C to 40°C
Power Supply
output current
1A maximum
output voltage
7.5 VDC
input power
120 VAC
OpenHouse
®
Cable/DSL Router
ATTACH THE ROUTER TO
THE MB-56 MOUNTING PLATE
WITH THE DOUBLE-SIDED
FOAM TAPE SUPPLIED
THE MB-56 MOUNTING PLATE
WITH THE DOUBLE-SIDED
FOAM TAPE SUPPLIED
ATTACH
HORIZONTAL
OR ATTACH
VERTICAL
PULL THE SNAP LATCH
PLUNGER OUT THEN
HOOK THE MOUNTING
PLATE INTO THE GRID
FROM THE BOTTOM
PLUNGER OUT THEN
HOOK THE MOUNTING
PLATE INTO THE GRID
FROM THE BOTTOM
PRESS THE SNAP
LATCH PLUNGER
TO LOCK THE
PLATE
LATCH PLUNGER
TO LOCK THE
PLATE
Typical Broadband Cable Installation
Using Additional Hubs or Switches for Expansion
• Use only Category 5e unshielded twisted-pair cable for maximum
• Use only Category 5e unshielded twisted-pair cable for maximum
performance.
• When connecting additional hubs or switches, use a straight
through or crossover RJ-45 Category 5e cable. Category 5 patch
cords may be used for short interconnections.
cords may be used for short interconnections.
• The cable length between any two hubs or switches cannot
exceed 100 meters (328 feet).
• All additional hubs or switches used must be self-powered.
Declaration of Conformity
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which if found by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet other than the receiver’s outlet.
• Consult a dealer or an experienced radio/TV technician for assistance.
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which if found by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet other than the receiver’s outlet.
• Consult a dealer or an experienced radio/TV technician for assistance.
4
3
2
1
WAN
DC IN
From
DSL modem
To
computers
7.5 VDC
from power
adapter
4
3
2
1
WAN
DC
IN
H628
Cat-5
Termination
Hub
DC Input
from 7.5 VDC
Power Adapter
DSL connection
from telephone
company
from telephone
company
To data jacks in
remote wall plates.
Connect up to four
computers or external
hubs or switches.
remote wall plates.
Connect up to four
computers or external
hubs or switches.
Many modems may be
mounted by using an MB-55
or MB-56 mounting bracket
mounted by using an MB-55
or MB-56 mounting bracket
DSL modem
IN
OUT
H634
Cable/DSL
Router
4
3
2
1
WAN
DC IN
From
cable modem
To
computers
7.5 VDC
from power
adapter
4
3
2
1
WAN
DC
IN
Filter
Splitter
H628
Cat-5
Termination
Hub
DC Input
from 7.5 VDC
Power Adapter
broadband
from cable
company
from cable
company
To data jacks in
remote wall plates.
Connect up to four
computers or external
hubs or switches.
remote wall plates.
Connect up to four
computers or external
hubs or switches.
Many modems may be
mounted by using an MB-55
or MB-56 mounting bracket
mounted by using an MB-55
or MB-56 mounting bracket
Cable modem
IN
OUT
H634
Cable/DSL
Router
to TVs
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,H634 - LINEAR P/N: 222323 A - INK: PROCESS COLOR - MATERIAL: 113 GSM WHITE COATED - SIZE: 11.000” X 15.000” - SCALE: 1-1 - FOLDING: 2-FOLD ALTERNATE, 2-FOLD HORIZONTAL INTO THIRDS (FINISH HAS LOGOS SHOWING) - SIDE 1 OF 2