Calflame bbq07877p Benutzeranleitung

2007 Pizza Oven Owner’s Manual 

Page 5

LTR20071039, Rev. A

Vent the enclosure for an LP gas cylindar with openings 

at the level of the cylinder valve and at the floor level. 
Ensure one side of the enclosure is completely open.
For enclosures that have four sides, complete with a 

top and bottom:

At least two ventilation openings at cylinder valve         

less than one square inch per pound (7.1 cm²/kg) 

of stored fuel capacity and not less than a total free 

area of 10 square inches (64.5cm²). If ventilation 

openings at floor level are in a sidewall, there 

shall be at least two openings. The bottom of the 

openings shall be at floor level and the upper edge 

no more than 5 inches (127 mm) above the floor. 

The openings shall be equally sized, spaced at 

180º (3.14 rad) and unobstructed.

•

Every opening shall have minimum dimensions so 

as to permit the entrance of a 1/8 inch (3.2 mm) 

diameter rod.

Place the dust cap on the cylinder valve outlet 

whenever the cylinder is not in use. Only install the type 

of dust cap on the cylinder valve outlet that is provided 

with the cylinder valve. Other types of caps or plugs 

may result in leakage of propane.
Transport only one cylinder at a time. Ensure the 

cylinder is secured in an upright position with the 

control valve turned off and the dust cap in place. Store 

cylinders outdoors and out of reach of children. Do 

not store cylinders in a building, garage, or any other 

enclosed area.

•

Warning: All pizza ovens use LP unless they are 

converted to natural gas. Do not connect natural gas to 

an unconverted pizza oven!

Always check the rating plate to make sure the gas 

supply you are hooking up to is the gas type the pizza 

oven is manufactured for.
IMPORTANT: Never connect the pizza oven to an 

unregulated gas supply.
The installation of this appliance must conform with 

local codes or, in the absence of local codes, to the 

national fuel gas code, ANSI Z223.1a-1998. Installation 

in Canada must be in accordance with the standard 

CAN/CGA-B149.2, Propane Installation Code.
A licensed contractor or local gas company 

representative must perform all natural gas 

connections.
Ensure that the service supplying the pizza oven is 

fitted with a shut off valve conveniently positioned near 

the pizza oven and giving ease of access.
The pizza oven and its individual shutoff valve must be 

disconnected from the gas supply piping system during 

any pressure testing of that system at test pressure in 

excess of 0.5 psi (3.5 kPa).

Your pizza oven for use with natural gas comes 

equipped with its own regulator that MUST NOT 

be removed. If this regulator needs to be replaced, 

use only the type specified by Cal Flame™ for this 

appliance.

Remove the rear panel from the pizza oven to gain 

access to the regulator and gas connection point.
Connect a suitable flex connector to the regulator.
Check the controls to ensure all control valves are 

in the full OFF position.
Turn on the main gas supply and check all 

connections for leaks using soapy water as 

described in the leak testing procedure section.

Warning: If you see bubbles in the soapy solution at 

any of the connections, turn off the gas supply and 

tighten the connection. If tightening the connection 

does not seal the leak, it may be necessary to replace 

the flex hose.

1.

2.
3.

4.