Revel gem Betriebsanweisung

A-4

Follow the instructions to install the Ultima Gem® 2 Loudspeaker 
to the pedestal.

Step 1: Lay the Ultima Gem

®

2 pedestal down, face up, on a

soft non-scratch surface.

Step 2: Find and remove the four Phillips pan-head screws
from the accessories bag that was removed from the end pad
during the unpacking procedure.

Step 3: Remove the wall mount bracket from the loudspeaker
accessories kit. This bracket is the matching half of the bracket
that is installed on the back of the loudspeaker.

Step 4: Place the bracket flat against the front of the inset area of the 
pedestal, so that the screw holes line up between the pedestal and 
the bracket. Be sure to position the bracket so that the out-thrust 
tabs are on the bottom end. These are the stops that keep the 
speaker from sliding off the bracket.

Step 5: Secure the bracket in place with the four
Phillips pan-head screws. Be sure to use the outer
holes for the screws, leaving the two center holes
empty. Tighten the screws firmly but do NOT
over-tighten.

Step 6: Lay the pedestal face down on a soft
non-scratch surface, so that the back of the
pedestal is facing up.

Step 7: Install the combination spikes/glides with
the felt washers and knurled locking rings to the
bottom of the pedestal. Hand-tighten the spikes
firmly, but do NOT over-tighten.

Step 8: Put the cables for the loudspeaker in the hole located on the 
rear of the pedestal near the bottom and then feed the cables 
through the pedestal so that they come out at the top end on the 
front of the pedestal.

1.

Select the appropriate end of the spikes/glides 
depending on your surface. If the speaker is to 
be used on a hardwood floor or smooth surface 
use the glide end of the spike.

2.

Locate the four threaded insets on the bottom of 
the pedestal.

3.

Screw the first spike into the threaded insert, 
making sure to include the locking ring & felt 
washer in the order shown. 

4.

Repeat Step 3 with each of the other spikes 
and threaded insets. Make sure the spikes are 
evenly threaded to achieve a level balance.

Step 9: Install the cables to the rear panel of the
loudspeaker.

Step 10: The loudspeaker can now be installed onto
the pedestal. 

If the wires have enough play, stand the pedestal
back onto its base and slide the loudspeaker onto
the bracket from above, as shown. Make sure the
brackets are firmly mated before releasing the
loudspeaker.

If the wires do not have enough play to allow the
pedestal to be righted, slide the speaker sideways
from the top of the pedestal and over the bracket.
Make sure that the brackets are firmly mated before
moving the pedestal back to an upright position.

Step 10: Adjust the combination spikes/glides to
level the speaker as required. Hand-tighten the
locking rings after adjustment.

Back

Felt

Locking

Spike 

Washer

Ring

End Down