Panasonic AG-HMC150 Betriebsanweisung

93

Sets the output video format of the HDMI OUT terminal. 
AUTO:   Automatically determines the output resolution based on information of 

connected monitors. 

FIX:  

 Fix the output at the recorded resolution. 
(Output in 1080 interlaced or 720 progressive mode)

480P:  Output in 480 progressive mode. 

Simultaneous HDMI and component output is possible only in FIX mode.
There will be no VIDEO OUT output when connected with an HDMI cable if this 
item is set to anything other than FIX.

•
•

Selects the type of component terminal.
AUTO:  Monitor with D4 terminal (720P/1080i output)
1080i:  Monitor with D3 terminal (1080i output)
480i:  

Monitor with D1 terminal (480i output)

Cross-conversion is only performed when content recorded at 720P is output at 
1080i. Cross-conversion does not take place in other cases.

•

Switches down-conversion output mode.
SIDE CROP: Crops the right and left edges of the image for a 4:3 aspect ratio.

Images may extend beyond the boundaries of the screen and be partially 
unable to be seen when outputting from the VIDEO OUT terminal, or when 
outputting from the COMPONENT OUT terminal when the COMPNT OUT SEL 
item is set to 480i.

LETTER BOX:  Adds black bands at the top and bottom of the image to display 

16:9 images on a 4:3 screen.

Squeezes 16:9 images horizontally when displaying on a 4:3 
screen.

•

Sets the setup level of video signals.
0%:  

 VIDEO OUT terminal output and recording setup levels will both be set 
to 0%.

7.5% A:   VIDEO OUT terminal output setup level will be set to 7.5%, while 

recording setup level will be set to 0%.

Sets the audio signals to output from the AUDIO OUT pin jack.
CH1/CH2: 

CH1 terminal = CH1 signals, CH2 terminal = CH2 signals

CH1:   CH1 terminal = CH1 signals, CH2 terminal = CH1 signals
CH2: 

 

CH1 terminal = CH2 signals, CH2 terminal = CH2 signals

When an SD Memory Card containing 5.1 channel content, recorded on other 
equipment, is played back on the camera, it is down-mixed to 2 channels when 
output through the AUDIO OUT or headphone terminal. 

•

Selects the sound heard through the headphones.
LIVE: 

 

 The sound which has been input from the microphone is output as 
is. This setting is selected when delays in the sound are annoying.

RECORDING:   The sound in the status which is to be recorded (the sound 

synchronized with the images) is output.

        indicates the factory setting.