Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Panasonic
  4. AG-HPX170
  5. Betriebsanweisung

Panasonic AG-HPX170 Betriebsanweisung

Download
Seite von 128
Shooting
9
Recharging the built-in battery
The camera’s internal battery saves the date and 
time. “ 
 ” appears on the screen of the viewfinder 
or LCD when the internal battery is running low on 
charge.
Do the following to recharge it.
Reset the date and time when fully recharged.
1
  Connect the AC adapter. (Page 1)
Leave the POWER switch at OFF.
  Leave the camera-recorder like this for 
about  hours.
The internal battery charges during this time.
Recharge the battery regularly to ensure 
correct TC and menu operations.
If “ 
 ” appears even after charging, it means that 
the internal battery must be replaced. Ask your 
dealer to do this.
Setting the time code
In the setup menus, RECORDING SETUP 
screen, set the following time code related items. 
(Page 105)
TC MODE
TCG
TC PRESET
19 TC REGEN (appears when in MCR mode)
In MCR mode and 1394 TC REGEN is ON, you 
cannot change the items shown above.
•
•
•
•
•
•
•
Specifying the time code (TC PRESET)
Set TC PRESET so you can record a value of your 
choice as the initial setting for the time code to be 
used at the start of recording.
1
  Set the POWER switch to ON.
  On the setting menu RECORDING SETUP 
screen, push the Operation lever in the e 
or r direction to move to TC PRESET and 
press it again.
RECORDING SETUP
PUSH  MENU TO RETURN
MIC GAIN2
-50dB
2CH
DF
REC RUN
––––
FRM.RATE
––––
OFF
25M REC CH SEL
UB MODE
UB PRESET
TC MODE
TCG
TC PRESET
TIME STAMP
  Push the Operation lever in the r direction 
to move to YES and press it again.
RECORDING SETUP
PUSH  MENU TO RETURN
MIC GAIN2
-50dB
2CH
DF
REC RUN
––––
YES
––––
OFF
25M REC CH SEL
UB MODE
UB PRESET
TC MODE
TCG
TC PRESET
TIME STAMP
  When the screen below appears, set the 
time code value.
Push the Operation lever in the e or r 
direction to select a time code value.
TC PRESET
PUSH  MENU TO RETURN
MONTH
+/– : PUSH q / g
0
 0 h 0 0 m 0 0 s 0 0 f
SEL : PUSH t / y
(Continued on the next page)
Charging the built-in battery/Setting the time data