Panasonic AJ-HPX2000 Benutzerhandbuch
14
Parts and their Functions
：Power Supply and Accessory Mounting Section
1.
POWER switch
Used to turn on/off the power.
2.
Battery mount
A battery pack from Anton/Bauer is mounted here.
3.
DC IN (external power input) socket (XLR, 4P)
camera-recorder is connected to an external DC
power supply.
power supply.
4.
BREAKER switch
When an excessive amount of current is fed through
the camera-recorder, due to any abnormal event, the
breaker automatically turns off the power in order to
protect the device.
After the interior of the camera-recorder has been
checked and/or repaired, this button must be
depressed. If there is no unusual reaction, the unit can
be powered-up.
the camera-recorder, due to any abnormal event, the
breaker automatically turns off the power in order to
protect the device.
After the interior of the camera-recorder has been
checked and/or repaired, this button must be
depressed. If there is no unusual reaction, the unit can
be powered-up.
5.
GPS connector
This connects the optional GPS unit AJ-GPS910G.
6.
Shoulder strap fittings
The shoulder strap is attached here.
7.
Light shoe
A video light or similar accessory can be attached
here.
here.
8.
Lens mount (bayonet 2/3-type)
The lens is attached here.
9.
Lens lever
Lower this lever to lock the lens to the lens mount.
10.
Lens mount cap
To remove the cap, raise the 9. lens lever.
When the lens is not mounted, replace the cap.
When the lens is not mounted, replace the cap.
11.
Light cable clamp
Secures the light cable.
12.
Lens cable/microphone cable clamp
This clamp secures the lens and microphone cables.
13.
Tripod mount
When you want to mount camera-recorder on a tripod,
the optional tripod adapter (SHAN-TM700) is attached
here.
the optional tripod adapter (SHAN-TM700) is attached
here.
14.
LENS jack (12-pin)
The lens connection cord is connected here. For a
detailed description of your lens, see the relevant
manufacturer’s instruction manual.
detailed description of your lens, see the relevant
manufacturer’s instruction manual.
15.
DC OUT (DC power supply) output socket
This output socket is designed for 12-VDC. It provides
a maximum current of 1.5 A.
Connect an external switch to this socket to control
REC starts and stops or an LED for use as a tally
lamp. For more information, see [Connection of the
external switch
a maximum current of 1.5 A.
Connect an external switch to this socket to control
REC starts and stops or an LED for use as a tally
lamp. For more information, see [Connection of the
external switch
1
2
3
4
6
15
5
7
6
9
8
10
14
12
13
11
Parts and their Functions
Power Supply and Accessory Mounting Section
AJ-HPX2000P(VQT1D27-1)E.book 14 ページ ２００７年７月３０日 月曜日 午後１時３１分