Panasonic HDC-SD5 Benutzerhandbuch

Seite von 144
26
VQT1H62
Setup
Setup
Charging the battery
When this unit is purchased, the battery is not 
charged. Charge the battery before using this 
unit.
≥ Connect the battery to an AC adaptor to 
recharge it.
≥ Refer to page 28 concerning batteries that 
can be used with this unit.
1
Connect the AC cable to the AC 
adaptor and the AC outlet.
≥ Remove the DC cable beforehand.
2
Put the battery on the battery 
mount by aligning the mark, and 
then securely plug it in.
≥ The output plug of the AC cable is not 
completely connected to the AC adaptor jack. 
As shown in A, there is a gap.
ª Charging lamp
Lights up:
Charging
Goes off:
Charging completed
Flashing:
Make sure that the terminals of the battery or the 
AC adaptor are not exposed to dirt, foreign 
objects or dust, then reconnect them properly.
Disconnect the AC cable from the AC outlet 
when you remove dirt, foreign objects or dust on 
the terminals of the battery or the AC adaptor.
If the charging lamp is still flashing, something 
may be wrong with the battery or AC adaptor. 
Contact your dealer.
≥ Battery charging time (
l 28)
≥ We recommend using Panasonic batteries 
(l 10, 28, 132).
≥ If you use other batteries, we cannot guarantee 
the performance/quality of this product.
If the DC cable is connected to the AC 
adaptor, then the battery will not charge. 
Remove the DC cable from the AC adaptor.
A
VQT1H62_ENG_PP.book  26 ページ  2007年7月17日 火曜日 午後5時44分