Panasonic HDC-SD5 Benutzerhandbuch
39
VQT1H62
Setup
3
Press the MENU button to exit
the menu screen.
the menu screen.
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥ Move the cursor button up or down to select
message asking you to set the date and time will
appear.
≥ Move the cursor button up or down to select
[YES], press the cursor button and then
perform steps 2 and 3 below to set the date
and time.
perform steps 2 and 3 below to set the date
and time.
If the screen shows the incorrect date and time,
then adjust it.
then adjust it.
¬Rotate the mode dial to select
.
1
Press the MENU button, then
select [BASIC]
select [BASIC]
# [CLOCK SET]
# [YES] and press the cursor
button.
2
Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 12-hour system is used to display the time.
3
Press the cursor button to enter
the selection.
the selection.
≥ The clock function starts at [00] seconds when
the cursor button is pressed.
≥ Press the MENU button to finish the setting.
Check the date and time displayed.
Changing the date and time display style
Press the MENU button, then select [SETUP]
#
[DATE/TIME]
# desired display style and press
the cursor button.
≥ You can also show or change the date and
≥ You can also show or change the date and
time display by repeatedly pressing the DATE/
TIME button on the remote control.
TIME button on the remote control.
Changing the display style
Press the MENU button, then select [SETUP]
#
[DATE FORMAT]
# desired display style and
press the cursor button.
≥ The date and time function are driven by a
built-in lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in
≥ If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery.
steps to charge the battery.
To recharge the built-in lithium battery:
If you connect the AC adaptor or insert the
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
When you turn on the power for the first time
after charging, a message asking you to set the
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
When you turn on the power for the first time
after charging, a message asking you to set the
MENU
ENTER
[DATE]
[D/T]
[OFF]
Display style
Screen display
[Y/M/D]
2008. 1. 1
[M/D/Y]
JAN 1 2008
[D/M/Y]
1. 1. 2008
JAN 1 2008 12:34PM
JAN 1 2008
VQT1H62_ENG_PP.book 39 ページ ２００７年７月１７日 火曜日 午後５時４４分