Panasonic HDC-SD5 Benutzerhandbuch

Seite von 144
43
VQT1H62
Recording
Recording motion pictures
Record motion pictures on an SD card.
≥ Use an SD card that can be used for motion 
picture recording. (25)
≥ This unit records high definition images that 
are compatible with the 16:9 aspect ratio of a 
wide-screen TV.
1
Rotate the mode dial to select 
.
The lens cover opens automatically.
2
Open the LCD monitor.
3
Press the recording start/stop 
button to start recording.
≥ While recording is in progress, the recording 
will not stop even if the LCD monitor is closed.
To end the recording
Press the recording start/stop button again to 
pause recording.
≥ [¥] and [;] are red during recording. Do not 
move this unit until [;] is green.
≥ The images recorded between pressing the 
recording start/stop button to start recording 
and pressing it again to pause recording 
become one scene.
≥ When about 5 minutes have passed without 
any operation in recording pause, the unit 
automatically turns off to prevent the battery 
from running down. When you want to use the 
unit, turn it on again.
This setting can also be set to [OFF]. (l 109, 
[POWER SAVE])
ª Screen indications in the 
recording mode
Recording mode
Remaining time left for recording
(When the remaining time is less than 
1 minute, [R0min] flashes red.)
Recording time elapsed
≥ Maximum number of recordable scenes: 999
Maximum number of recordable scenes with 
different dates: 99 (In some cases, scenes 
shot on the same day will be recorded with 
different dates. (l 66))
When either of them reaches to the maximum 
limit, more scenes cannot be recorded.
≥ SD cards with more than the maximum scenes 
or different dates cannot be used with this unit.
≥ Sound is recorded from the internal 
microphones on the top of this unit. Take care 
not to cover the microphone with your hand.
≥ Each time the unit is put into recording pause, 
the counter display will be reset to 
“0h00m00s”.
≥ When recording motion pictures, do not 
remove the battery or disconnect the AC 
adaptor. Also, do not open the SD card/battery 
cover and remove the SD card while the card 
access lamp lights up. If you do either of the 
above, the scene recovery message is 
displayed and the recovery operation will begin 
when the SD card is next inserted or the power 
is turned back on. (l 113, About recovery)
B
C
1920
HG
A
VQT1H62_ENG_PP.book  43 ページ  2007年7月17日 火曜日 午後5時44分