Panasonic PV-GS36 Bedienungsanleitung

•  We recommend using a Panasonic Battery.
•  We cannot guarantee the quality of this Camcorder 

when batteries from other companies are used.

Before use, fully charge the Battery.

A

Charging Time
Maximum Continuous Recording Time
Intermittent Recordable Time

B

•  “1 h 40 min.” indicates 1 hour and 40 minutes.
•  Battery CGR-DU06 is supplied.
•  The times shown in the table are approximate 

times. The numbers indicate the recording time 
when the Viewfinder is used. The numbers in 
parentheses indicate the recording time when the 
LCD Monitor is used. In actual use, the available 
recording time may be shorter.

•  The times shown in the table are for continuous 

recording at a temperature of 25 °C (77 °F) and 
humidity of 60 %. If the Battery is charged at a 
higher or lower temperature, the charging time may 
be longer.

•  We recommend the Battery Pack CGA-DU12 and 

CGA-DU21 for long time recording (2 hours or 
more for continuous recording, 1 hour or more for 
intermittent recording.)

•  The available recording time becomes shorter 

if you use both of Viewfinder and LCD Monitor 
simultaneously when rotating the LCD Monitor 
forward to record yourself.

•  The batteries heat up after use or charging. The 

Camcorder being used will also heat up. This is 
normal.

•  Along with the reduction of the battery capacity, 

the display will change: 

 → 

 → 

 → 

 → 

. If the battery discharges, then 

 

(

) will flash.

Supplied battery
CGR-DU06 
(7.2 V / 640 mAh)

A

1 h 40 min.

B

1 h 50 min. (1 h 25 min.)

C

55 min. (45 min.)

Optional battery
CGA-DU12
(7.2 V / 1 150 mAh)

A

2 h 25 min.

B

3 h 15 min. (2 h 40 min.)

C

1 h 40 min. (1 h 20 min.)

Optional battery
CGA-DU21
(7.2 V / 2 040 mAh)

A

3 h 55 min.

B

5 h 45 min. (4 h 30 min.)

C

2 h 55 min. (2 h 15 min.)

(The intermittent recordable time refers to recordable 
time when the recording and stopping operations are 
repeated.)

C

•  When the Camcorder has been used for a long 

time, the Camera body becomes warm, but this is 
not a malfunction.

•  If the [CHARGE] Lamp does not light up although 

the Battery is attached to the AC Adaptor, detach 
the Battery and reattach it.

•  Since the Battery will not be charged when 

the DC Cable is connected to the AC Adaptor, 
disconnect it from the AC Adaptor.

•  The [CHARGE] Lamp lights up, and charging 

starts.

•  When the [CHARGE] Lamp goes off, charging 

is completed.

•  When the battery is completely discharged, the 

[CHARGE] Lamp blinks at first, but the battery 
is charged normally. When the temperature of 
the battery is too high or low, the [CHARGE] 
Lamp blinks and the charging time becomes 
longer than usual.

„

Set the [OFF/ON] Switch to [OFF], and while 
sliding the [BATTERY RELEASE] Switch, remove 
the Battery downward or DC Cable.
•  When attaching or removing Battery, set the 

[OFF/ON] Switch to [OFF] and make sure the 
[STATUS] Indicator is not lit.

•  Hold down the battery with your hand so it 

does not fall.