Panasonic PV-GS9 Benutzerhandbuch

Before using

LSQT1284

When Quick Start is ON the battery power is still 
being consumed, even when the LCD Monitor 
and the Viewfinder are closed.
The Camcorder will resume recording/pause 
mode about 1.7 seconds after the LCD Monitor or 
the Viewfinder is reopened.
≥Please note in Quick Start Mode approximately 

half the pause recording power is being 
consumed. Using Quick Start Mode will reduce 
the battery recording/playback time.

≥This is only activated in the following cases.

≥While using the battery

A tape is inserted, while the Tape Recording 
Mode is set.

≥While using the AC adaptor

Quick Start can be used even if a tape is not 
inserted.

≥Set to Tape Recording Mode.

Set [SETUP] >> [QUICK START] >> [ON]. 
(

)

≥The Status indicator lights green and the unit 

goes into quick start standby mode.

≥The Camcorder will not go into quick start 

standby mode unless the LCD monitor is 
closed and the viewfinder is retracted.

≥The status indicator lights red and the 

Camcorder is put into recording pause 
approx. 1.7 seconds after it is turned on.

ª

Set [SETUP] >> [QUICK START] >> [OFF]. 
(

)

≥The status indicator goes off and the power 

turns off if the mode dial is set to OFF while the 
unit is in quick start standby mode.

≥If the standby continues for approx. 30 minutes, 

then the Status indicator will go off and the 
Camcorder will be completely turned off.

≥In the following cases, quick start is canceled 

and the power turns off.

≥When the Mode dial is moved.
≥When the battery or AC adaptor is removed.
≥When the tape is removed while using the 

battery in Tape Recording Mode.

≥When the Camcorder is quick-started with the 

white balance on automatic, it may take some 
time until the white balance is adjusted if the 
scene being recorded has a light source 
different from the scene last recorded. (When 
the MagicPix function is used, however, the 
white balance of the scene last recorded is 
retained.)

≥If the power is turned on in quick start standby 

mode, the zoom magnification becomes 2

t and 

the picture size may differ from what it was 
before quick start standby mode.

≥If [POWER SAVE] (

) is set to [5 MINUTES] 

and the unit automatically goes into quick start 
standby mode, close the LCD monitor and 
retract the viewfinder and then open the LCD 
monitor or extend the viewfinder again.

PV-GS90P_LSQT1284_Eng.book  17 ページ  ２００７年１１月２８日　水曜日　午前９時２０分