Panasonic PV-GS9 Benutzerhandbuch

Others

LSQT1284

Power/Body
1: The Camcorder power cannot be turned on.
• Is the battery fully charged? Use a fully 

charged battery.

• The battery protection circuit may have 

operated. Insert the battery to the AC adaptor 
for 5 to 10 seconds. If the Camcorder still 
cannot be used, the battery is faulty.

• Make sure the LCD monitor is opened or the 

viewfinder extended.

• If you do not use the unit for approximately 

5 minutes, the power is automatically turned off 
to conserve battery life. To resume recording, 
turn the power back on. The power will not turn 
off automatically when the power save function 
is set to [OFF]. (

)

• Is the battery low? If the remaining battery 

power indication is flashing or the message 
“LOW BATTERY” is displayed, the battery has 
run down. Charge the battery or attach a fully 
charged battery. (

)

• Has condensation occurred? When you carry 

the Camcorder from a cold place into a warm 
place, condensation may occur inside it. If so, 
the power is turned off automatically, disabling 
all operations except for taking cassettes out. 
Wait until the condensation indication 
disappears. (

)

4: Battery runs down quickly.
• Is the battery fully charged? Charge it with the 

AC adaptor. (

)

• Are you using the battery in an extremely cold 

place? The battery is affected by ambient 
temperature. In cold places, the operating time 
of the battery becomes shorter.

• Has the battery worn out? The battery has a 

limited life. If the operating time is still too short 
even after the battery is fully charged, 
depending on the usage, the battery has worn 
out and needs to be replaced.

• The Camcorder cannot be operated unless you 

open the LCD monitor or extend the viewfinder.

• Remove the cassette and then press the 

[RESET] button. (

) If normal conditions are 

not restored yet, turn off the power. Then, 
about 1 minute later, turn on the power again.

6: The cassette cannot be removed.
• Does the status indicator comes on when 

opening the cassette cover? (

) Make sure 

that the battery and the AC adaptor are 
properly connected. (

)

• Is the battery in use discharged? Charge the 

battery and remove the cassette.

• Close the cassette cover completely, and fully 

open it again. (

)

• Has condensation occurred? Wait until the 

condensation indication disappears. (

)

• Is the accidental erasure prevention slider on 

the cassette open? If it is open (set to [SAVE]), 
recording cannot be performed. (

)

• Is the tape wound to the end? Insert a new 

cassette.

• Is the recording mode set? When in the 

playback mode, recording cannot be 
performed. (

)

• Has condensation occurred? No operation 

other than cassette removal can be performed 
when condensation occurs. Wait until the 
condensation indication disappears. (

)

• Is the cassette cover open? If the cover is 

open, the Camcorder may not operate 
normally. Close the cassette cover. (

)

• Has the demonstration started? In the Tape 

Recording mode, if you set [DEMO MODE] >> 
[ON] without inserting a cassette, the 
demonstration starts. For normal use, set this 
function to [OFF]. (

)

3: A cassette cannot be inserted.
• Has condensation occurred? Wait until the 

condensation indication disappears.

4: Auto focus function does not work.
• Is manual focus mode selected? If auto focus 

mode is selected, focus is automatically 
adjusted.

• There are some recording subjects and 

surroundings for which the auto focus does not 
operate correctly. (

) If so, use the manual 

focus mode to adjust the focus. (

)

• Read the contents and respond to them. (

)

PV-GS90P_LSQT1284_Eng.book  44 ページ  ２００７年１１月２８日　水曜日　午前９時２０分