Panasonic VDR-M70 Benutzerhandbuch

Set the power switch to “OFF” 
to turn the DVD Video Camera 
off.

Press down the DISC EJECT 
lever once and release it. 

In a moment, the cover of disc 
insertion compartment will 
open slightly.

Gently open the cover until it 
stops.

When the cover is fully open, 
the disc will slightly come out 
from the disc guide, and stop.

Remove the disc.

Hold the top of Round 
DVD Holder as shown in 
the illustration and 
gently pull it out.

Be careful not to touch the 
exposed disc portion 
when removing the disc.

Gently push the section 
indicated “PUSH CLOSE” 
on the cover of disc insertion 
compartment (on side) to 
close the cover.

Even after the DVD Video Camera is turned on, the disc
can be removed unless it is in recording status. Hold
down the DISC EJECT lever for approximately 2
seconds, and then release it to remove the disc. (The
DISC EJECT indicator on the LCD screen will blink.) It is
recommended that you turn the DVD Video Camera off
before inserting or removing disc to prevent
misoperation.

Do not remove the battery pack or disconnect the AC 
adaptor during removal of the disc or until power is 
completely turned off: If you do, the disc cover will not 
open. If this happens, reattach the battery pack or AC 
adaptor, push down the DISC EJECT lever once, and 
then release it.

Do not insert anything other than the 8 cm DVD-RAM or 
DVD-R disc into the disc insertion block: Doing so could 
cause malfunctions.

Set the power switch to “OFF” to turn the DVD Video 
Camera off.

When inserting or removing the disc, be careful not to 
touch the inside of DVD Video Camera [especially, the 
lens of laser pickup (see “Terminology” on page 148 )].

When inserting or removing the disc, connect a charged 
battery pack or AC adaptor to the DVD Video Camera: 
The disc cover will not open unless the DVD Video 
Camera is powered.

DISC EJECT

When grasping the holder, 

avoid the exposed disc 

portion.