WatchGuard x1000 Hardwarehandbuch

Seite von 30
Hardware Guide
Firebox III
Hardware Guide
Firebox 700, Firebox 1000, Firebox 2500, Firebox 4500

Zusammenfassung der Spezifikationen hardwarehandbuch für WatchGuard x1000

  • Seite 1Firebox III Hardware Guide Firebox 700, Firebox 1000, Firebox 2500, Firebox 4500 Hardware Guide
  • Seite 2Copyright and Patent Information Copyright© 1998 - 2001 WatchGuard Technologies, Inc. All rights reserved. This documentation and the software described...
  • Seite 3: Table of ContentsTable of Contents Limited Hardware Warranty ........................................................... 5 FCC Certification ............................................................................ 8 CE Notice ....................................................................................... 9 Industry Canada ............................................................................. 9...
  • Seite 4 Firebox System Area .................................................................... 24 Read-only system area 25 Enhanced System Mode 25 Managing flash disk memory 25 Index...
  • Seite 5 Hardware Guide The WatchGuard Firebox III is a specially designed and optimized security appliance. Solid-state architecture removes the risk...
  • Seite 6CHAPTER 2: and used for its intended purpose and in its intended operating environment, will perform substantially in accordance with...
  • Seite 7 Limited Hardware Warranty 4. Limitation of Liability. WATCHGUARD TECHNOLOGIES’ LIABILITY (WHETHER ARISING IN CONTRACT (INCLUDING WARRANTY), TORT (INCLUDING ACTIVE,...
  • Seite 8CHAPTER 2: FCC Certification This device has been tested and found to comply with limits for a Class A digital...
  • Seite 9 CE Notice • This device must accept any interference received, including interference that may cause undesired operation. CE Notice...
  • Seite 10CHAPTER 2: Taiwanese Notice VCCI Notice Class A ITE 10 Hardware Guide
  • Seite 11 Installing the Firebox III Installing the Firebox III Easily installed into your network, the rack-mountable Firebox plugs in at...
  • Seite 12CHAPTER 2: Locating a Firebox within a network One of the first steps in installing a Firebox is determining where...
  • Seite 13 Installing the Firebox III You can connect to and initialize a new Firebox in several ways: • Using TCP/IP....
  • Seite 14CHAPTER 2: 3 Install the power cord from the Firebox AC receptacle to a power source. 4 When prompted to...
  • Seite 15 Installing the Firebox III • The Management Station is running Firebox System 4.6 or later, which has IP connectivity...
  • Seite 16CHAPTER 2: file and saves it to the primary area of the Firebox flash disk. The Firebox loads the primary...
  • Seite 17 Hardware Description Firebox III front view (all models except Model 700) Indicators for the Firebox III Model 1000, Model...
  • Seite 18CHAPTER 2: Sys A Indicates that the Firebox is running from its primary user- defined configuration. Sys B Indicates that...
  • Seite 19 Hardware Description The following photograph shows a close-up of the indicator panel. From the left, the indicators are as...
  • Seite 20CHAPTER 2: Sys B Indicates that the Firebox is running from the read-only factory default system area. Power Indicates that...
  • Seite 21 Hardware Description PCI Expansion Slot Reserved for future use. Factory Default This button is active only during the boot...
  • Seite 22CHAPTER 2: AC Receptacle Accepts the detachable AC power cord supplied with the Firebox. Power Switch Turns the Firebox on...
  • Seite 23 Hardware Description (NICs) are auto-sensing and adapt to wire speed automatically. The speed indicator lights when there is a...
  • Seite 24CHAPTER 2: The tables below provide pin-out descriptions for both a straight-through and a RJ-45 (Cat5) cross-over cable. Pin Number...
  • Seite 25 Firebox System Area older functions and a new set of features designed to enhance usability, called the enhanced system...
  • Seite 26CHAPTER 2: Making a backup of the Firebox software To ensure that you always have a backup version of the...
  • Seite 27 Firebox System Area Note that this procedure is possible only when a backup image is on the backup area...
  • Seite 28CHAPTER 2: 28 Hardware Guide
  • Seite 29: IndexIndex F Factory Default button 21, 22 factory default system area and Sys B light 18, 20 FCC certification 8...
  • Seite 30 traffic 18 installation 11 R read-only system area 24, 25 remote provisioning L and Process Load Indicator 15 and...
downloadlike
ArtboardArtboardArtboard