Whistler gps100 Anleitung Für Quick Setup

Seite von 1
INTRODUCTION
Dear Whistler Owner,
Thank you for purchasing the
Whistler Galileo™ GPS.  Please take
time to read this guide, see our
Frequently Asked Questions on GPS
at www.whistlergroup.com, or call
Customer Service at 800-531-0004, 
M-F 8am-5pm CT, for additional
assistance with your Galileo.
Sincerely,
The Whistler Group
THE WHISTLER GROUP, INC.
13016 N. Walton Blvd.
Bentonville, AR 72712
TEL (479) 273-6012  Fax (479) 273-2927
www.whistlergroup.com
P/N 501030 ©  2003 The Whistler Group, Inc.
QUICK
START-UP GUIDE
SET UP
BATTERIES/
COMPACT FLASH (CF) CARD
Remove the battery compartment cover, 
insert Compact Flash Card and insert 2 AA
batteries.  Note: The CF card is for detailed 
mapping only.
TURNING ON
Press        for 2 seconds
VERTICAL/HORIZONTAL SCREEN
Press               and hold
ADJUSTING CONTRAST
From Satellite Page,
move the         to the left or right
Press       when finished.
SET UP
BACKLIGHT
Press        to turn on or off.
See “Setting” to change on time.
SET TIME
Go to Trip Page
Press            Press     ,
Move         up to Hour
Press    ,
Press         to correct time
Press          Move  
to              Press         
SET UP
NAVIGATION
NAVIGATION
NAVIGATION
MAP PAGE
Displays current
position and 
coordinates with
“Zoom In and Zoom
Out” options.
TRIP PAGE
Displays information
as you travel, such as
compass heading,
speed, track, odometer,
trip time, altitude,
speed, location, time
and date.
COMPASS PAGE
Displays current 
direction, distance and
time to next waypoint,
route, and final 
destination.  (picture
shown displays route
feature on.)
TRACK LOG-ON
(BREAD CRUMBS)
Leaves a trail behind
to help you find your
way back. 
SETTING
Press          ,
Select “Setting”, press     
to change backlight, navigation mode,
NMEA output, map direction and 
units (miles vs. kilometers).
CHANGE TO 
SIMULATION MODE
From Satellite Page, press     
to “Stop Navigation”, Press     
SELECT NAVIGATION MODE
From Satellite Page, press     
to “Navigation”, Press      
TO SET A WAYPOINT
From Map Page move           
to a chosen location, 
Press and hold
To use default name press
To rename, press         to name field,
Press       ,        up/down to field through
alphabet, left/right to next letter,
Press
NAVIGATION
SATELLITE  PAGE
Displays satellites
available, battery 
status, location 
coordinates, signal
strength and 
backlight on/off.