Wyse v90le Anleitung Für Quick Setup
Wyse Customer Support
QSG - WSI 1.3.6 v3.doc
Pager 3 of 15
S
UMMARY
This is a Quick Start Guide to help you install and run the Wyse Simple Imager version
1.3.6
1.3.6
A
UDIENCE
Customers, 1
st
Level Support, and Systems Engineering Group
A
FFECTED
P
RODUCTS
Wyse Simple Imager V1.3.6
R
EQUIREMENTS
/I
SSUES
Execution of this application requires
• A Windows 2000 server SP4 or Windows 2003 SP1 server (If you wish to use
Windows XP Pro SP2, see important notes below), IN AN ISOLATED NETWORK.
•
IT CANNOT BE INSTALLED ON THE SAME SERVER WITH WYSE DEVICE
MANAGER
MANAGER
.
•
The WSI server and Thin Client MUST BE CONNECTED
TO EACH OTHER BEFORE INSTALLING THE
TO EACH OTHER BEFORE INSTALLING THE
SOFTWARE. Failure to connect the devices before
installation will result in a loopback network condition and a
subsequent inability to re-image your thin clients.
• DHCP, IIS with FTP Services installed and running
• Single network adapter supported. If you have two adapters, you must disable one
• All software firewalls and Antivirus services stopped
• A simple hub, unmanaged (inexpensive) switch or a crossover cable
• Wyse Simple Imager software V1.3.6
• An image file for the device requiring the image
• Single network adapter supported. If you have two adapters, you must disable one
• All software firewalls and Antivirus services stopped
• A simple hub, unmanaged (inexpensive) switch or a crossover cable
• Wyse Simple Imager software V1.3.6
• An image file for the device requiring the image
IMPORTANT for Windows XP Pro SP2 Users:
1.
You will need to provide a working DHCP server. Windows XP Pro does not
include one.
include one.
2.
When installing and using WSI, ensure to run it on an isolated network.
3.
See Page 7 for installation instructions on Windows XP Pro.
NOTE: If a previous version of WSI exists, you must remove it before installing this
version.
version.