Wyse v90le Anleitung Für Quick Setup

Seite von 15
Wyse Customer Support
                                    
 
 
QSG - WSI 1.3.6 v3.doc 
Pager 7 of 15 
 
WSI
 INSTALLATION ON A 
W
INDOWS 
XP
 
P
ROFESSIONAL 
M
ACHINE
 
Follow these three steps: 
 
1.  CONNECT: 
Connect your Windows XP Professional machine and the device(s) 
you need to re-image via a simple hub, unmanaged switch or a 
crossover cable
. Verify that the Thin Client has power, a monitor, 
keyboard and mouse attached, but it’s NOT powered-on. During the WSI 
installation, a Proxy server is installed. If the devices are not connected, a 
loopback network connection is created and you will not be able to image 
your devices. 
Note: Disable all software firewalls and antivirus. 
 
2.  INSTALL: 
Install the required software components IIS, FTP, DHCP and WSI.  
Note: For this example we are using DHCP turbo. This program is not 
supplied nor supported by Wyse. 
 
3.  CONFIGURE: 
Configure TCP/IP properties, TFTPD, DHCP turbo and FTP in that order. 
 
TCP/IP properties (See Figure 6) 
Set the TCP/IP properties for the alternate configuration as follows: 
 
 
IP address:    
10.1.1.12 
 
Subnet mask:  
255.255.255.0 
 
Default gateway: 
10.1.1.254 
 
 
Figure 6 - Alternate Configuration Settings.