ENVISION en8500 Benutzerhandbuch
EN-8500
4
NOTES
The following symptoms are normal with LCD monitor and do not indicate a
problem.
problem.
•
Due to the nature of thefluorescent light, the screen may flicker during
initial use. Turn off the Power Switch and then turn it on again to make
sure the flicker disappears.
sure the flicker disappears.
•
You may find slightly uneven brightness on the screen depending on the
desktop pattern you use.
•
The LCD panel used in this monitor is a very high technology product with
2,359,296 thin film transistors giving you fine picture details. Occasionally,
a few non-active pixels may appear on the screen as a fixed point of red,
green, blue, white or black. Please note that this does not indicate a
defective panel.
a few non-active pixels may appear on the screen as a fixed point of red,
green, blue, white or black. Please note that this does not indicate a
defective panel.
•
Due to the nature of the LCD screen, an afterimage of the previous
screen may remain after switching the image when the same image has
been displayed for a long time. The monitor will slowly recover from this.
been displayed for a long time. The monitor will slowly recover from this.
•
The life of the fluorescent light used in the LCD monitor is approximately
30,000 hours. Contact your dealer or EPI service center for replacement
when the screen is dark, flickering or not lighting up. Never attempt to
replace it by yourself.
when the screen is dark, flickering or not lighting up. Never attempt to
replace it by yourself.
SPECIAL NOTES ON LCD MONITORS