3com 8807 Verweisanleitung
OSPF Configuration Commands
451
Parameter
seconds: Interval in seconds for an interface to transmit hello packet. It ranges
from 1 to 255.
from 1 to 255.
Description
Use the ospf timer hello command to configure the interval for transmitting
Hello packets on an interface.
Hello packets on an interface.
Use the undo ospf timer hello command to restore the interval to the default
value.
value.
By default, the interval is 10 seconds for an interface of broadcast type to
transmit Hello packets.
transmit Hello packets.
Related command: ospf timer dead.
Example
# Configure the interval for transmitting Hello packets on the interface
Vlan-interface 10 to 20 seconds.
Vlan-interface 10 to 20 seconds.
[SW8800] interface Vlan-interface 10
[3Com-Vlan-interface10] ospf timer hello 20
ospf timer retransmit
Syntax
ospf timer retransmit interval
undo ospf timer retransmit
View
Interface view
Parameter
interval: Interval in seconds for re-transmitting LSA on an interface. It ranges from
1 to 65,535. The default value is 5 seconds.
1 to 65,535. The default value is 5 seconds.
Description
Use the ospf timer retransmit command to configure the interval for LSA
re-transmitting on an interface.
re-transmitting on an interface.
Use the undo ospf timer retransmit command to restore the default interval
value for LSA re-transmitting on the interface.
value for LSA re-transmitting on the interface.
If a router running OSPF transmits a "link state advertisement" (LSA) to the peer, it
needs to wait for the acknowledgement packet from the peer. If no
acknowledgement is received from the peer within the LSA retransmit, this LSA
will be re-transmitted. This command can change the interval of re-transmitting
LSA. However, according to RFC2328, the LSA retransmit between adjacent
routers should not be set too short. Otherwise, unexpected re-transmission will be
caused.
needs to wait for the acknowledgement packet from the peer. If no
acknowledgement is received from the peer within the LSA retransmit, this LSA
will be re-transmitted. This command can change the interval of re-transmitting
LSA. However, according to RFC2328, the LSA retransmit between adjacent
routers should not be set too short. Otherwise, unexpected re-transmission will be
caused.