3com 2928 Betriebsanweisung
1-13
Click Modify Port to enter the page for modifying the VLANs to which a port belongs, as shown in
.
Figure 1-14
Assign GigabitEthernet 1/0/1 to VLAN 2, and VLAN 6 through VLAN 50 as a tagged
member
z
Select GigabitEthernet 1/0/1 on the chassis front device panel.
z
Select the Tagged radio button.
z
Type in VLAN IDs 2, 6-50.
z
Click Apply. A configuration progress dialog box appears.
z
After the configuration process is complete, click Close in the dialog box.
2) Configure Switch B
Configure Switch B as you configure Switch A.
Configure Switch B as you configure Switch A.
Configuration Guidelines
When configuring VLAN, note that:
1) VLAN 1 is the default VLAN, which can be neither created nor removed manually.
2) Some VLANs are reserved for some special purposes. You can neither create nor remove them
1) VLAN 1 is the default VLAN, which can be neither created nor removed manually.
2) Some VLANs are reserved for some special purposes. You can neither create nor remove them
manually.
3) Dynamic VLANs cannot be removed on the page for removing VLANs.
4) You cannot remove a VLAN that has referenced a QoS policy.
5) You cannot directly remove a VLAN configured as a remote probe VLAN. To remove the VLAN,
4) You cannot remove a VLAN that has referenced a QoS policy.
5) You cannot directly remove a VLAN configured as a remote probe VLAN. To remove the VLAN,
you must remove the remote probe VLAN configuration first.