3com 2928 Betriebsanweisung

 

3-1 

 

z

 

The 3Com baseline switch 2900 family can be configured through the command line interface (CLI), 
web interface, and SNMP/MIB, among which the web interface supports all switch 2900 series 
configurations. These configuration methods are suitable for different application scenarios. As a 
supplementary to the web interface, the CLI provides some configuration commands to facilitate 
your operation, which are described in this chapter. To perform other configurations not supported 
by the CLI, use the web interface.  

z

 

You will enter user view directly after you log in to the device. Commands in the document are all 
performed in user view. 

 

As a supplementary to the web interface, the CLI provides some configuration commands to facilitate 
your operation. For example, if you forget the IP address of VLAN-interface 1 and cannot log in to the 
device through the Web interface, you can connect the console port of the device to a PC, and 
reconfigure the IP address of VLAN-interface 1 through the CLI. 
This section describes using the CLI to manage the device. 

Set up the configuration environment as follows: 

Take the console cable out of the package. (A console cable is an 8-core shielded cable. One end of the 
cable is a crimped RJ-45 connector, which is connected to the console port of the switch, and the other 
end is a DB-9 female connector, which is connected to the serial port on the console terminal, as shown 
below.)