3com 2928 Betriebsanweisung
1-24
z
Click the Global Setup tab.
z
Select Enable from the LLDP Enable dropdown list.
z
Click Apply.
Configuration verification
# Display the status information of port GigabitEthernet1/0/2 on Switch A.
z
Select Network > LLDP from the navigation tree to enter the Port Setup tab.
z
Click the GigabitEthernet1/0/2 port name in the port list.
z
Click the Status Information tab at the lower half of the page. The output shows that port
GigabitEthernet 1/0/2 is connected to a non-MED neighbor device, that is, Switch B, as shown in
GigabitEthernet 1/0/2 is connected to a non-MED neighbor device, that is, Switch B, as shown in
.
Figure 1-20
The Status Information tab
# Tear down the link between Switch A and Switch B.
# Display the status information of port GigabitEthernet1/0/2 on Switch A.
z
Click Refresh. The updated status information of port GigabitEthernet 1/0/2 shows that no
neighbor device is connected to the port, as shown in
neighbor device is connected to the port, as shown in
Figure 1-21
The Status Information tab displaying the updated port status information