3com S7906E Installationsanweisungen

 

1-22 

 

Configure the LDP transport 
address 

 

{ ip-address | interface } 

Optional 
MPLS LSR ID of the LSR by 
default 

 

If you configure an LDP transport address by specifying an IP address, the specified IP address must 
be the IP address of an interface on the device. Otherwise, the LDP sessions cannot be established. 

 

Configure a remote session transport address by specifying an IP address. 

Follow these steps to configure remote LDP session parameters: 

Enter system view 

— 

Create a remote peer entity and 
enter MPLS LDP remote peer 
view 

mpls ldp remote-peer 
remote

-peer-name 

Required 

Configure the remote peer IP 
address 

remote-ip ip-address 

Required 

Configure LDP to advertise 
prefix-based labels through a 
remote session 

Optional 
By default, LDP does not 
advertise prefix-based labels 
through a remote session. 

Set the targeted Hello timer 

 hello-hold 

value 

Optional 
45 seconds by default 

Set the targeted Keepalive 
timer 

 

 value 

Optional 
45 seconds by default 

Configure the transport 
address 

 

ip-address 

Optional 
MPLS LSR ID of the LSR by 
default 

 

By default, LDP does not advertise any prefix-based label mapping message through a remote session, 
and remote sessions are used only to transfer messages for L2VPNs. For applications of remote 
sessions, refer to information about Martini MPLS L2VPN configuration in MPLS L2VPN Configuration 
of the MPLS Volume.