3com S7906E Installationsanweisungen
1-56
1.1.1.9:2054 3.3.3.9 -/Vlan4 Tunnel1
Configuring ordinary CR-LSP backup is almost the same as configuring hot CR-LSP backup except that
you need to replace the mpls te backup hot-standby command with the mpls te backup ordinary
command. Unlike in hot CR-LSP backup where a secondary tunnel is created immediately upon
creation of a primary tunnel, in ordinary CR-LSP backup, a secondary CR-LSP is created only after the
primary LSP goes down.
you need to replace the mpls te backup hot-standby command with the mpls te backup ordinary
command. Unlike in hot CR-LSP backup where a secondary tunnel is created immediately upon
creation of a primary tunnel, in ordinary CR-LSP backup, a secondary CR-LSP is created only after the
primary LSP goes down.
6) Create a static route for routing MPLS TE tunnel traffic
[SwitchA] ip route-static 20.1.1.2 24 tunnel 3 preference 1
Perform the display ip routing-table command on Switch A. You can find a static route entry with
Tunnel1 as the outgoing interface.
Tunnel1 as the outgoing interface.
FRR Configuration Example
Network requirements
On a primary LSP Switch A → Switch B → Switch C → Switch D, use FRR to protect the link Switch B →
Switch C and use BFD to detect the status of link Switch B→Switch C.
Switch C and use BFD to detect the status of link Switch B→Switch C.
Do the following:
z
Create a bypass LSP that traverses the path Switch B → Switch E → Switch C. Switch B is the PLR
and Switch C is the MP.
and Switch C is the MP.
z
Explicitly route the primary TE tunnel and the bypass TE tunnel with the signaling protocol being
RSVP-TE.
RSVP-TE.
Figure 1-10
Link protection using the FRR approach
Switch A
Switch B
Switch C
Switch D
Switch E
Vlan-int1
Loop0
Loop0
Loop0
Loop0
Vlan-int1
Vlan-int2
Vlan-int2
Vlan-int3
Vlan-int3
Vlan-int4
Vlan-int4
Primary LSP
Bypass LSP
Vlan-int5
Vlan-int5
Loop0
Device Interface IP
address
Device Interface IP
address
Switch A
Loop0
1.1.1.1/32
Switch E
Loop0
5.5.5.5/32
Vlan-int1 2.1.1.1/24
Vlan-int4 3.2.1.2/24
Switch B
Loop0
2.2.2.2/32
Vlan-int5
3.3.1.1/24
Vlan-int1
2.1.1.2/24
Switch C
Loop0
3.3.3.3/32
Vlan-int2 3.1.1.1/24
Vlan-int3 4.1.1.1/24
Vlan-int4 3.2.1.1/24
Vlan-int2 3.1.1.2/24
Switch D
Loop0
4.4.4.4/32
Vlan-int5
3.3.1.2/24