3com S7906E Installationsanweisungen
1-6
z
BGP: For details, refer to BGP Configuration and BGP Commands in the IP Routing Volume.
z
MPLS: For details, refer to MPLS Basics Configuration and MPLS Basics Commands in the MPLS
Volume.
z
Track: For details, refer to Track Configuration and Track Commands in the High Availability
Volume.
Protocols and Standards
z
draft-ietf-bfd-base-05: Protocol Independent Bidirectional Forwarding Detection
z
draft-ietf-bfd-v4v6-1hop-05: BFD for IPv4 and IPv6 (Single Hop)
Configuring BFD Basic Functions
The BFD basic function configuration is the basis for configuring BFD for other protocols.
Configuration Prerequisites
Before configuring BFD detection modes, complete the following tasks:
z
Configure the network layer addresses of the interfaces so that adjacent nodes are reachable to
each other at the network layer;
z
Configure the routing protocols that support BFD
Configuration Procedure
Follow these steps to configure BFD basic functions:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Specify the mode for
establishing a BFD session
establishing a BFD session
bfd session init-mode { active
| passive }
| passive }
Optional
active by default
Enter interface view
interface interface-type
interface-number
interface-number
—
Configure the minimum interval
for transmitting BFD control
packets
for transmitting BFD control
packets
bfd min-transmit-interval
value
value
Optional
The value defaults to 400.
Configure the minimum interval
for receiving BFD echo packets
for receiving BFD echo packets
bfd
min-echo-receive-interval
value
min-echo-receive-interval
value
Optional
The value defaults to 400.
Configure the minimum interval
for receiving BFD control
packets
for receiving BFD control
packets
bfd min-receive-interval
value
value
Optional
The value defaults to 400.
Configure the maximum
number of consecutive BFD
packets that the remote device
fails to receive from the local
device before considering the
BFD session down
number of consecutive BFD
packets that the remote device
fails to receive from the local
device before considering the
BFD session down
bfd detect-multiplier value
Optional
5 by default