3com S7906E Installationsanweisungen
1-10
Configuration Procedure
Follow these steps to configure an IPv6 manual tunnel:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable IPv6
ipv6
Required
By default, the IPv6 packet
forwarding function is disabled.
forwarding function is disabled.
Enter tunnel interface view
interface tunnel number
—
ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
prefix-length |
ipv6-address/prefix-length }
Configure a
global unicast
IPv6 address
or a site-local
address
global unicast
IPv6 address
or a site-local
address
ipv6 address
ipv6-address/prefix-length
eui-64
ipv6-address/prefix-length
eui-64
Required
Use either command.
By default, no IPv6 global
unicast address or site-local
address is configured for the
tunnel interface.
unicast address or site-local
address is configured for the
tunnel interface.
ipv6 address auto link-local
Configure an
IPv6 address
for the tunnel
interface
IPv6 address
for the tunnel
interface
Configure a
link-local IPv6
address
link-local IPv6
address
ipv6 address ipv6-address
link-local
link-local
Optional
By default, a link-local address
will automatically be created
when an IPv6 global unicast
address or site-local address is
configured.
will automatically be created
when an IPv6 global unicast
address or site-local address is
configured.
Specify the IPv6 manual tunnel
mode
mode
tunnel-protocol ipv6-ipv4
Required
By default, the tunnel is a GRE
over IPv4 tunnel. The same
tunnel mode should be
configured at both ends of the
tunnel. Otherwise, packet
delivery will fail.
over IPv4 tunnel. The same
tunnel mode should be
configured at both ends of the
tunnel. Otherwise, packet
delivery will fail.
Configure a source address or
interface for the tunnel
interface for the tunnel
source { ip-address |
interface-type
interface-number }
interface-type
interface-number }
Required
By default, no source address or
interface is configured for the
tunnel.
interface is configured for the
tunnel.
Configure a destination
address for the tunnel
address for the tunnel
destination ip-address
Required
By default, no destination
address is configured for the
tunnel.
address is configured for the
tunnel.