3com S7906E Installationsanweisungen

 

1-13 

[SwitchB] route-policy isis2ospf permit node 20 

[SwitchB-route-policy] if-match acl 2002 

[SwitchB-route-policy] apply tag 20 

[SwitchB-route-policy] quit 

[SwitchB] route-policy isis2ospf permit node 30 

[SwitchB-route-policy] quit 

6)  Apply the route policy to route redistribution. 

# On Switch B, apply the route policy when redistributing routes. 

[SwitchB] ospf  

[SwitchB-ospf-1] import-route isis 1 route-policy isis2ospf 

[SwitchB-ospf-1] quit 

# Display the OSPF routing table on Switch A. The cost of route 172.17.1.0/24 is 100, the tag of route 

172.17.1.0/24 is 20. 

[SwitchA] display ospf routing 

 

          OSPF Process 1 with Router ID 192.168.1.1 

                   Routing Tables 

 

 Routing for Network 

 Destination        Cost     Type    NextHop         AdvRouter     Area 

 192.168.1.0/24       1     Transit    192.168.1.1     192.168.1.1   0.0.0.0 

 

 Routing for ASEs 

 Destination        Cost     Type    Tag         NextHop       AdvRouter 

 172.17.1.0/24      100      Type2   1           192.168.1.2   192.168.2.2 

 172.17.2.0/24      1        Type2   20          192.168.1.2   192.168.2.2 

 172.17.3.0/24      1        Type2   1           192.168.1.2   192.168.2.2 

 192.168.2.0/24     1        Type2   1           192.168.1.2   192.168.2.2 

 

 Total Nets: 5 

 Intra Area: 1  Inter Area: 0  ASE: 4  NSSA: 0 

As shown in the following figure: 

z 

Enable RIPng on Switch A and Switch B.  

z 

On Switch A, configure three static routes, and apply a route policy to static route redistribution to 

permit routes 20::0/32 and 40::0/32, and deny route 30::0/32. 

z 

Display RIPng routing table information on Switch B to verify the configuration.