3com S7906E Verweisanleitung
1-4
Examples
# Set the GARP join timer to 25 centiseconds, assuming that both the hold timer and the leave timer are
using the default.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] garp timer join 25
garp timer leaveall
Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Default Level
2: System level
Parameters
timer-value: Leaveall timer setting, in the range 65 to 32765 (in centiseconds), Note that the setting of
the leaveall timer must be a multiple of 5 centiseconds and must be greater than the leave timer settings
of all the ports.
Description
Use the garp timer leaveall command to set the leaveall timer of GARP.
Use the undo garp timer leaveall command to restore the default. This may fail if the default is less
than the setting of the current leave timer.
By default, the setting of the leaveall timer is 1000 centiseconds (that is, 10 seconds).
A leaveall timer starts upon the start of a GARP application entity. When this timer expires, the entity
sends a LeaveAll message so that other entities can re-register its attribute information and starts
another leaveall timer at the same time.
Each time a device on the network receives a LeaveAll message, it resets its leaveall timer. Therefore,
a GARP application entity may send LeaveAll messages at the interval set by its leaveall timer or the
leaveall timer on another device on the network, whichever is smaller.
Related commands: display garp timer.
Examples
# Set the leaveall timer to 100 centiseconds, assuming that the leave timer is 60 centiseconds.
<Sysname> system-view
[Sysname] garp timer leaveall 100