Cavalry cada001u32a Benutzerhandbuch

8. 

Decide which RAID setting 
you want, and, following 

the diagram to the right, 
move the jumper shunts to 

cover the appropriate pins. 
(On the diagram to the 

right, grey indicates that a 
pin is covered; white 

indicates an uncovered pin.) 

 

The jumper shunts may be 

moved by gently pulling 
them upwards (vertically) 

until they are free, then 
pushing them downwards 

onto the appropriate two 
pins. 

 
NOTE: If switching from any mode to RAID 1 mode, you must first configure 
the jumper block to “Single” mode. Then connect your drive to your 

computer, turn on your drive, and repeat step 5 (un-initialization) on BOTH 
drives (in single mode, the array will show up as two drives). Then you may 

continue again from Step 6 and configure the jumper block to RAID 1.   
 

NOTE: When placing the jumper shunts, make sure they are oriented 
along the longest axis of the drive. For example, if you want RAID 1 

mode, one jumper shunt would cover pins 1 and 2, and another jumper shunt 
would cover pins 4 and 5, as opposed to one jumper shunt covering pins 1 
and 4, and another jumper shunt covering pins 2 and 5.  

 

Fig. A (below) shows how the [uncovered] jumper pins are numbered. The 

black arrow points to the back of the drive.  

 

 

 

 

14