Xerox 4517 Betriebsanweisung
E n v e l o p e F e e d e r
C-50 ❖ D o c u P r i n t 4 5 1 7
/
4 5 1 7 m p U s e r G u i d e
4
Remove the face plate and store it.
The face plate is re-installed after
removing the feeder.
removing the feeder.
5
Angle the Envelope Feeder into the
printer.
6
Allow the Envelope Feeder to rest down
at its seated position.
7
Reconnect the power cord(s) and power
ON the printer.
After warming up for a few minutes, the
Control Panel displays the following
message:
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.
Table 6.2 starting on page 6-6.
8
Print a Configuration Sheet and check
that the Envelope Feeder appears in the
“Installed Options” section. If not,
remove it as per Steps 1 to 2 on
page C-52, then repeat Steps 5 to 8 of this
procedure.
chapterc.frm Page 50 Friday, July 11, 1997 9:25 PM