Gestetner c7528 Zusätzliches Handbuch

Paper and Other Media

28

C

Press the {U} or {T} key to display [Paper Type], and then press the {# En-
ter} key.

The paper tray selection menu appears.

D

Press the {U} or {T} key to display the target paper tray, and then press
the {# Enter} key.

The paper type selection menu appears.

E

Press the {U} or {T} key to display the loaded paper type, and then
press the {# Enter} key.

After about two seconds, the display returns to the menu.

F

Press the {Online} key.

The initial screen appears.

Besides plain paper, you can use the bypass tray to load thick paper, envelopes,
OHP transparencies, paper longer than A3L, and paper that cannot be loaded
in the paper trays or paper feed unit.

• Set the size and direction of the loaded paper on the control panel or with the

printer driver. Make sure the settings do not conflict. Otherwise, the paper
may jam or the print quality may be affected.

❒ The bypass tray can accommodate sheets 90-305 mm(3.5”-12.01”) wide and

148-457 mm(5.8”-18”) long. However, the paper size must be set using the
control panel. When using the RPCS

TM

 printer driver, sheets of up to 1260

mm(49.61”) in length can be set.

❒ If you load custom size paper or special paper, select the paper size using the

control panel. The RPCS

TM

 printer driver can select the paper size using the

printer driver properties. The paper size selected using the printer driver over-
rides that selected using the control panel. See 

.

❒ If you load thick paper, OHP transparencies, or envelopes, make the settings

for thick paper or OHP transparencies using the control panel or printer driver.
See 

  Paper Type:

   Tray 2

  Tray 2

  *Recycled Paper