Gestetner c7528 Installationsanleitung

Seite von 140
Installing Options
49
 : Available option
 : Standard equipment
❒ Only one of the three types of paper feed unit can be installed at the same
time.
❒ To install a finisher, contact your service representative.
❒ The printer's ethernet and USB ports are not available when the gigabit eth-
ernet board is attached to the printer. Use the ethernet port and USB port
mounted on the board instead.
Option Installation Flow Chart
We recommend you install multiple options in the following order:
A
Attach the 500, 1000-sheet paper feed unit, or 2000-sheet large capacity
tray. (Paper Feed Unit Type 7300, Paper Bank Type 7300)
Attach the paper feed unit to the bottom of the printer.
You can install the Paper Feed Unit Type 7300 (500 
× 1), Paper Feed Unit
Type 7300 (500 
× 2) or Paper Bank Type 7300.
If you install the Paper Bank Type 7300, you can load up to 3,100 sheets of
paper at once.
B
Install the SDRAM module. (Memory Unit Type C)
Install the module to the SDRAM module slot on the controller board.
There are two types of memory unit: 64 MB, 128 MB, and 256 MB.
C
Install the user account enhance unit. (User Account Enhance Unit Type
E)
Install the module to the user account enhance unit slot of the controller
board.
D
Install the hard disk drive. (Printer Hard Disk Type 7100)
Install the hard disk drive to the controller board.
IEEE 1284 Interface Board Type A
USB Host Interface Unit Type 7300
User Account Enhance Unit Type E
Camera direct print card Type 7300
Basic model printer
Duplex unit standard mod-
el printer