Gestetner c7528 Bedienungsanleitung

Monitoring and Configuring the Printer

240

• You can specify the interval at which the printer synchronizes with the op-

erator-specified NTP server. The default is 60 minutes.

• The interval can be entered between 16 and 16,384 minutes.

• If you set 0, the printer synchronizes with the NTP server only when you

turn the printer on. After that, the printer does not synchronize with the NTP
server.

❖ Time-zone configuration

• You can specify the time difference between the printer clock and NTP

server clock. Time is in 24-hour format.

Use the “spoolsw” command to configure Job Spool settings.

You can only specify diprint, lpr, ipp, ftp and smb protocol.

• The “spoolsw” command for configuring Job Spool settings is available only

when the hard disk is installed.

❖ View settings

The Job Spool setting appears.

❖ Job Spool setting

❒ Specify “on” to enable Job Spool, or “off” to disable it.

❖ Resetting Job spool setting

• When the printer power is cut during job spooling, this determines whether

to reprint the spooled job.

❖ Protocol configuration

• You can specify the settings for diprint, lpr, ipp, and smb.