ONKYO TX-SR303 Gebrauchsanleitung

29

Connecting Your  Components—Continued

With 

 (Remote Interactive) you can use the following special 

 functions:

When you start playback on a component connected via 

, if the AV receiver is in Standby, it will turn on and select 

that component as the input source automatically. Similarly, when the AV receiver is set to Standby, all components 
connected via 

 will also enter Standby. This function will not work if a component’s power cord is connected to the 

AV receiver’s AC OUTLET.

When playback is started on a component connected via 

, the AV receiver automatically selects that component as 

the input source. If the DVD player is connected to the AV receiver’s multichannel input, you must press the 
[MULTI CH] button (see page 35) to listen to all channels because the Direct Change 

 function selects only the DVD 

IN FRONT jacks.

• Use only 

 cables for 

 connections. 

 

cables are supplied with Onkyo players (DVD, 
CD, etc.).

• Some components have two 

 jacks, you can 

connect either one to the AV receiver. The other is 
for connecting additional 

-compatible compo-

nents.

• Connect the AV receiver’s 

 jack to only Onkyo 

components. Connecting to other manufacturer’s 
components may cause them to malfunction.

• Some components may not support all 

 func-

tions. Refer to the manuals supplied with your 
components.

• Before connecting the power cord, connect all of your speakers and AV components.

• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical 

equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.

Step 1: Be sure that the Onkyo component is connected to the AV receiver with an analog audio cable (RCA).

Step 2: Make the 

 connection.