Blaupunkt pa4100 Installationsanweisungen

Below is a basic trouble-shooting guide to assist in seeking out and correcting a problem that may occur in the installation
process.  Although lengthy, this chart cannot address every single problem possible but mainly the ones most common.  

Channels 4/3/2

Size ( W x H x D) 

10.4 x9.8x2.6 inches  (265x250x67mm)

Weight (with housing)

6.0 lbs (2.7 kg)

Crimping style speaker terminals? 

YES

Maximum terminal wire size 

10 ga.

Subsonic filter 

YES (10 Hz)

Separate front/rear or left/right gains? 

F/R YES, L/R NO

Fuse Type

ATC spade -2@40A

Speaker short, short to +12V, and short to ground protection? 

YES

High, low, and reverse voltage protection? 

YES

Power output transistors 

MOSFET

Switching power supply transistors 

MOSFET

Minimum speaker impedance  

(non-bridged)

2 ohms

(bridged)

4 ohms

Rated power output @ 0.1% THD, 13.8V

4 channels into 4 ohms / 2 ohms 

4 x 100 W / 4 x 125 W

2 channels into 4 ohms 

2 x 250 W

Total Harmonic Distortion @ rated full output 

0.03% THD

Rated Signal/Noise ratio (averaged value)

Measured @ 1 watt / 1 kHz  

dBA

82

Measured @ full rated power (0.1% THD)  dBA

>100

Damping factor 

>100

Frequency response (full-range mode) 

20 - 50,000 Hz

High-pass crossover frequency limits 

50 H z - 250 Hz (variable), 12dB/oct

Low-pass crossover frequency limits 

50 H z - 250 Hz (variable), 12dB/oct

Input impedance 

10 kohms

Input signal voltage control range 

0.3 - 6.0 vrms

Current Draw @ 13.8 VDC (typical values @ X watts / Efficiency %)

@ full rated power, bridged mode 

(@ 4 ohms)

70 A (65%)

@ full rated power, unbridged

(@ 4 ohms)

42 A (78%)

@ 33% rated power, unbridged

(@ 4 ohms)

16 A (60%)

@ 10% rated power, unbridged

(@ 4 ohms)

8 A (40%)

@ idle 

(@ 4 ohms)

2.5 A

Minimum battery voltage to maintain rated power 

12.6 VDC

Usable battery voltage 

10 - 16 VDC

Trigger line voltage range 

10 - 16 VDC

Trigger line current draw 

@ 20 mA

Turn on delay time 

@  2.0 seconds

Thermal shutoff temperature (average heat-sink temp) 

@ 85˚ C (185˚ F)

NOTE: DUE TO ONGOING PRODUCT IMPROVEMENTS, DESIGN AND SPECIFICATIONS ARE SUBJECT TO CHANGE
WITHOUT ADVANCED NOTICE TO THE CONSUMER OR RETAILER.