Infocus lp340 Zusätzliches Handbuch
Tech Tip
LP340/340B/350 Lamp Maintenance
Page 1
LP340/350 Lamp Maintenance
In dirty or dusty environments, the dust filter screens on LP340/350 lamp modules can become plugged,
causing excessively high temperatures inside the lamp module. The high temperatures can cause
premature lamp failure. Routine maintenance to remove dust and dirt from the filter screens lowers the
lamp operating temperature and lengthens lamp life.
causing excessively high temperatures inside the lamp module. The high temperatures can cause
premature lamp failure. Routine maintenance to remove dust and dirt from the filter screens lowers the
lamp operating temperature and lengthens lamp life.
This Tech Tip describes how to clean the lamp module dust filter screens. Clean them every 200-250
hours when the projector is used in areas with high levels of airborne contaminants like lint, dust or
smoke.
hours when the projector is used in areas with high levels of airborne contaminants like lint, dust or
smoke.
You must remove the lamp from the projector to clean the dust filter screens.
CAUTION!
The lamp module gets very hot during operation. Allow the lamp to cool for 30 minutes before
handling it.
Removing the lamp module
Remove the lamp door on the bottom of the projector by releasing the two tabs on the inside
edge of the door with your fingers. Then swing the door open.
edge of the door with your fingers. Then swing the door open.
If necessary, you can also use a coin. Take care not to scratch the finish on the projector.