Infocus LP70+ Betriebsanweisung

Seite von 67
4
I
n
t
r
o
d
u
c
t
i
o
n
Usage Guidelines
 Do not look directly into the projection lens when the projector 
is turned on. The bright light may harm your eyes.
 Do not block the grills on the projector. Restricting the air flow 
can cause it to overheat and turn off. If this happens, you must 
wait a minute before attempting to turn it back on.
 Handle the projector as you would any product with glass 
components. Be especially careful not to drop it.
 Avoid leaving the projector in direct sunlight or extreme cold 
for extended periods of time. If this happens, allow it to reach 
room temperature before use.
Transport the projector in a vendor-approved hard or soft case. 
Part numbers for these cases are listed on page 37. 
If You Need Assistance
The first place to look for help is in this manual. Be sure to check 
the guidelines in “Troubleshooting” on page 33. Or, check the 
Service and Support section of our website at 
http://www.infocus.com/service. 
You’ll find a Technical Library, 
FAQs, and support contacts including a technical support e-mail 
form.
Warranty
This product is backed by a limited warranty. The details of the 
warranty are printed at the back of this manual. An extended 
warranty plan may be purchased from your InFocus dealer. 
When sending your projector in for repair, InFocus recommends 
shipping the unit in its original packing material, or having a pro-
fessional packaging company pack the unit for shipping. Please 
insure your shipment for its full value.
LP70.book  Page 4  Friday, February 13, 2004  7:39 AM