Infocus LP770 Verweisanleitung

Plug the audio cable’s white connector into the Left Audio 
connector on the projector; plug the audio cable’s red connec-
tor into the Right Audio connector on the projector. 

The projector is compatible with these major broadcast video 
standards: NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, and SECAM. 
It automatically adjusts to optimize its performance for the 
incoming video. See “Video Signal” on page 26 for details. 

If your DVD player has (Y,Cb,Cr) outputs, use the Computer 1 or 
Computer 2 In connectors. Also select (Y,Cb,Cr) for Computer 
Input in the Signal menu (see “Computer Input” on page 28).

If your HDTV decoder has (Y,Pb,Pr) outputs, use the Computer 1 
or Computer 2 In connectors. Also select (Y,Pb,Pr) for Computer 
Input in the Signal menu. 
If your HDTV decoder has R, G, B output, select RGB for Com-
puter Input in the Signal menu.

Remove the lens cap.

Plug the power cord into the side of the projector, then plug it 
into the electrical outlet. A surge-protected power strip is rec-
ommended.

Press the power switch to put the projector in standby.

•

The Power LED lights red.

on page 31 for details.

Turn on the lamp by pressing the 

button on the remote 

or keypad (see Figure 12 on page 16).

•

After a brief warmup period, the InFocus startup screen 
appears. 

If you connected a video player, turn it on.

•

The video image should display on the projection screen. If 
a computer source is active, press the 

 button on the 

remote or keypad to display your video image. 

•

Use the 

or

buttons to adjust the volume.