Infocus lp740 Benutzerhandbuch
A t t a c h t h e M o u n t i n g P l a t e t o t h e P r o j e c t o r
6
Attach the Mounting Plate to the Projector
1
Set the projector on a table with the bottom
side up. Align the holes in the mounting plate
with the holes in the projector.
side up. Align the holes in the mounting plate
with the holes in the projector.
CAUTION: Use only the
hardware that is provided
with the LP 740 Ceiling
Mount. Using different
hardware may damage
your projector.
2
Insert the 3 screws into the 3 quick release
sleeves (Figure 3).
sleeves (Figure 3).
3
Loosely attach the screws and sleeves to the
holes in the projector as shown in Figure 3.
holes in the projector as shown in Figure 3.
4
Align the keyholes in the mounting bracket
with the screws in the projector. Slide the
mounting bracket until the quick release
sleeves are at the top of the keyhole slot.
with the screws in the projector. Slide the
mounting bracket until the quick release
sleeves are at the top of the keyhole slot.
5
Attach the 5mm knurled knob to the projector
in the location shown in Figure 3. Tighten the
three 5mm screws and the 5 mm knurled
knob. Be careful not to over-tighten the
screws.
in the location shown in Figure 3. Tighten the
three 5mm screws and the 5 mm knurled
knob. Be careful not to over-tighten the
screws.
F
IGURE
3
Attach the mounting plate to the projector
quick release screws
knurled knob
goes here