Infocus LP810 Informationshandbuch
LP810
How do I install a new lamp?
You access the lamp from the rear of the projector.
1. Unplug the projector and wait for 60 minutes for lamp to cool off.
2. Loosen the two screws that secure the lamp door to the projector. Then swing the door open.
2. Loosen the two screws that secure the lamp door to the projector. Then swing the door open.
3. Loosen the two screws that fasten the lamp to the projector. Then use the handle to pull the lamp out.
4. When you replace the lamp, make sure it seats securely before tightening the screws.
5. Make sure the lamp door completely shuts before tightening the screws. The projector will not operate if
5. Make sure the lamp door completely shuts before tightening the screws. The projector will not operate if
the lamp door is partially open.
6. If you installed a new lamp, make sure to reset the lamp counter.